Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7590

    Order66
    Participant

    The regs seem to read quite strictly about what holes you can drill in the bonnet, and say you can use bonnet pins, but don’t explicitly say that the small holes needed to rivet the small plates that the pin will sit agains are ok? So are they?

    #7591

    swift92sc
    Participant

    Hi,
    yes you can drill and fit bonnet pins using the screws provided or rivets (no issues)
    Best wishes, Glen

    #7593

    Order66
    Participant

    thanks, seems obvious but wanted to be 100% sure – no point in getting thrown out for simple stuff….

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.